The door lock is located just up inside the front of the machine.
Maytag 4000 series washer troubleshooting door locked.
Door lock motor and switch assembly the door lock secures the washer door shut during operation.
Aav4000aw series washer pdf manual download.
Nothing else will appear to be happening with the machine during this time.
Maytag washer repair help some common maytag front load washer problems include not agitating or spinning and not draining or filling with water.
Re select the cycle and press start.
Perhaps your washing machine is vibrating during spin cycles or making noises during wash cycles.
Reconnect power to washer plug in.
During this period you will be able to hear the pump running.
This is a guide about unlocking the door on a maytag front load washer.
Wait approximately 2 minutes for control to reset.
The door lock led light will blink.
Unplug washer or disconnect power for one minute.
The door should unlock after 60 seconds.
Ask your own appliance question.
When using one of these cycles the door will remain locked until the cancel button is pushed.
The door lock mechanism is broken.
If the door lock is defective the washer door will not latch properly.
Ok you will need to remove the lower front panel and reach up inside the unit on the right side of the door to manually unlock the door then try to run any cycle and see what it does.
The door may immediately unlock.
View and download maytag aav4000aw series service manual online.
Front loaders have a locking mechanism to avoid opening the door during a washing cycle but occasionally this lock will be activated accidentally.
Aav7000aj series aav7000aw series aav7000ak series aav7000ag series aav8000ag series aav8000aj series aav8005ew series aav9000ag series.
Once the washer door is closed the washer can begin operating.
Maytag 4000 front load washer put clothes in select cycle press start everything lights up starts the door locks and it never move to next cycle wash no water loads in the machine.
The door can be manually unlocked by.
Run a drain and spin cycle.
If the washer will not unlock at the end of a wash cycle unplug the washer or disconnect power.
Check the door switch lock unit for foreign objects.
